Fret slotting runout - Shapeoko

fret slot width   Dan fret slot width

fret slotting saw is the thing to have Combine this with a simple mitrebox and my stainless

You might need to joint the saw teeth if the kerf is too wide Use feeler gauges to measure the width of the saw kerf, and if it is too wide, A slot width of 6mm is standard The tang is always wider than the slot, especially where it

vue slot name Any saw will actually cut a slot that is slightly wider than its set width That saw would probably cut a slot of about 0,48mm in most woods  The tang has small bumps or barbs on its sides The traditional way of affixing the frets to the fretboard is to cut the slots to the width of the tang without